Do you have a question about the SkyLink ATOMS ATR Series and is the answer not in the manual?
Type | Garage Door Opener |
---|---|
Drive Type | Chain Drive |
Security | Rolling Code Technology |
Power Source | AC |
Horsepower | 1/2 HP |
Smart Home Compatibility | Yes |
Operating Range | 100 feet |
Compatibility | Compatible with most garage door openers |
General safety guidelines for assembly, operation, and maintenance of the opener.
Verify door balance, type, and condition before opener installation.
Precautions to reduce the risk of severe injury or death during installation and operation.
Procedures for testing the opener's safety features after installation.
Aligning and connecting multiple rail sections together.
Attaching trolley and sprocket assemblies to the rail sections.
Securing the rail assembly to the motor unit.
Connecting the turnbuckle and tightening the belt tension.
Mounting the header bracket at the marked height.
Attaching the rail assembly to the header bracket.
Plugging the opener into a grounded outlet.
Connecting the conduit and hardware for permanent wiring.
Attaching the sensor mounting brackets to the garage door track.
Adjusting sensor alignment and testing functionality with an obstruction.
Testing the door's ability to reverse upon encountering an obstruction.
Testing the functionality of the safety beam sensor.
Critical safety guidelines for operating the garage door opener.
Steps for removing and connecting the backup battery.
Connecting the backup battery harness to the opener.
Troubleshooting based on LED flashing patterns.
Troubleshooting based on LED display error codes.
Troubleshooting when the opener is unresponsive to controls.
Troubleshooting when the opener attempts action but the door remains stationary.
Troubleshooting when only one type of control is functional.
Troubleshooting when the door fails to open or close fully.
Troubleshooting when the opener light stays on or activates unexpectedly.
Troubleshooting causes of door reversing or unusual noise.