ITEM
SELECTION DESCRIPTION
System Setting
N iMHS e n sit i v i ty
D .Pe a k 4 mV
N iCdS e n sit i v i ty
D .Pe a k 4 mV
Default: 4mV/Cell
3-15mV/Cell
K ey Be e p O N
V oic e O N
OFF/ON
The beep sounds at every time touching
the buttons to confirm your action. The
beep or melody sounded at various times
during operation to alert different mode
changes.
D C Inp u t L ow
C ut- O f f 11. 0 V
10.0-12.0V
This program monitors the voltage of input
battery. If the voltage drops below the value
you set the operation forcibly terminated to
protect the input battery.
This program is for NiMH/NiCd battery only.
When the charger detects the delta peak
value reaches the value you set, the
charger will say the battery is fully charged.
L oad F a c tor y S e t
E nte r
V ers i o n
H W:1 . 0 0 FW: 2 . 0 0
Press ENTER to load factory default setting.
It indicates the hardware and firmware
version.
R est T i m e
C HG> D C HG 10 M i n
1-60Min
A rest time allowing the battery to cool
down between charging/discharging cycle.
· 28
D100 V2
To Next Page
Loading...
