• Indoor temperature display
• Outdoor temperature display via 433MHz transmission
• Wall mount or freestanding
• Current moon phase display
OUTDOOR TEMPERATURE TRANSMITTER:
• Remote transmission of outdoor
temperature to the atomic clock by 433
MHz signals
• Wall mounting case
TO INSTALL AND REPLACE BATTERIES IN THE ATOMIC CLOCK
The atomic clock uses 2 x AA, 1.5V batteries. To install and replace the batteries, please
follow the steps below:
1. Remove the cover.
2. Insert batteries observing the correct polarity (see marking inside battery compartment).
3. Replace compartment cover.
DO NOT SET THE CLOCK.
TO INSTALL AND REPLACE BATTERIES IN THE TEMPERATURE
TRANSMITTER
The transmitter uses 2 x AA,1.5V batteries. To install and replace the batteries, please follow
the steps below:
1. Remove the cover.
2. Insert the batteries, observing the correct polarity (see marking inside battery
compartment).
3. Replace the battery cover on the unit.
Alkaline batteries are recommended for use in both units. Avoid using rechargeable
batteries.
To Next Page
Loading...
