Slaughter 2945 - Quick Start; Instrument Defaults

QUICK START
25
QUICK START
This quick start guide assumes the operator has some familiarity with automated hipot
testing and desires to use the "default" settings on the instrument. The default settings
shown will remain in memory unless you choose to override them with your own test
program. The default settings will appear in memories 1 through 5 for models 2925, 2935,
and 2945. The instrument default settings are as follows:
DEFAULTS

Input Voltage: 115 or 230 volts AC country specific
(rear panel switch selectable)
 Lock: OFF
 Test: W - I (2945)
Dielectric Withstand Test Mode

Voltage Output: 1,240 volts AC

High Current Trip: HI-LMT: 10 mA

Low Current Trip: LO-LMT: 0 mA (2925 and 2935)

Ramp Timer: 0 second (2925, 2935, 2945)

Dwell Timer: 1 second

Voltage Type: AC

AC Output Frequency: 60Hz
 Continuity: OFF
Insulation Resistance Mode (model 2945)

Voltage Output: 1,000 volts DC

High Resistance Trip: I - High: 0 M

Low Resistance Trip: I - Low: 1 M

Delay Timer: 2 seconds