Slaughter 2945 - User Manual

OPERATION AND SERVICE MANUAL
Model 2925, 2935, 2945
MODEL 2925 (ENHANCED AC ONLY HIPOT WITH GROUND CONTINUITY CHECK)
MODEL 2935 (ENHANCED AC/DC HIPOT WITH GROUND CONTINUITY CHECK)
MODEL 2945 (ENHANCED AC/DC HIPOT WITH IR AND GROUND CONTINUITY)
SERIAL NUMBER
Models
2925,2935,2945
© Slaughter Company, Inc., 2004
28105 N. Keith Drive
Lake Forest, Illinois, 60045-4546
U.S.A.
Item 99-10090-01
Ver 1.05
Printed November 11, 2004

Summary

Section 1: Operators Manual

General Safety Precautions

Essential safety guidelines for high voltage testing, including warnings, cautions, and symbols.

Service, Maintenance, and Operator Guidelines

Covers user service, recommended calibration intervals, user modifications, operator qualifications, and procedures.

Test Procedures and Safety Points

Introduction

Specifications

Dielectric Withstand Test Mode Specifications

Detailed specifications for the dielectric withstand test mode, including voltage, frequency, and limits.

Measurement and Test Parameters

Insulation Resistance Test Mode Specifications

Controls

Front Panel Controls

Identifies and describes the function of each control on the front panel of the instrument.

Rear Panel Controls

Identifies and describes the function of each control and connector on the rear panel.

Installation

Preparation for Use and Power Requirements

Quick Start

Instrument Defaults

Initial Setup and Test Initiation

Guides the user through initial setup, connections, and starting a test.

Operation

Power Up and Setup Procedures

Steps for powering up and configuring test parameters like memory, type, voltage, and limits.

Operating Procedures and Test Execution

Describes how to perform tests, interpret results, handle failures, and abort tests.

Section 2: Service Manual

Calibration Procedures

Outlines the steps and equipment required for calibrating the instrument.

Specific Calibration Steps

Slaughter 2945 Specifications