Safety Notes
Your SLE Hot Printer and accessories have been designed to assure years of profitable, trouble-free
service, provided it is carefully maintained, handled with care and properly used. As with all
mechanical and electrical devices, it is essential that certain safety precautions be fully understood
and followed, to prevent injury to the operator and/or damage to the machine. In the interest of
safety, you are urged to read the following precautionary suggestions carefully before operating the
machine.
•
Place the machine on a stable counter or table, to prevent undue movement during operation.
•
Keep the work area clean and clutter free.
•
Do not operate this machine near water, wet locations, or outdoors.
•
This machine should be operated from the type of power source indicated on the marking
label. If you are not sure of the type of power available, consult your local power company.
•
Do not allow anything to rest on the power cord. Do not locate the machine where a person
will step on the cord. Inspect power cord regularly and replace any worn or damaged cord.
•
Use of an extension cord with this machine is not recommended or authorized. Users should
check building codes and insurance requirements if an extension cord is to be used. Ensure
that the total ampere ratings of the products plugged into the extension cord do not exceed
the extension cord rating.
•
Make sure that the total amperage of all products plugged into the wall outlet does not exceed
the outlet rating, and that outlet is properly fused according to its electrical ratings.
•
Toxic/inflammable material should not be placed near the machine. Do not attempt to imprint
on any object or product containing toxic/inflammable material.
•
Dress appropriately for the job. Do not wear any jewelry or loose clothing, which could
become entangled in the machine.
•
Avoid contacting the heated Type Holder/Heater Platen with bare hand as this may cause
severe burns. These portions of the machine can become very hot during operation.
•
Never place your hands on the printing table during operation of the machine.
•
When changing type sets or engravings, always use some form of protective gloves or the
supplied Holding Pad.
•
Keep this machine and all supplies out of reach of children.
•
Turn off machine when not in use. Unplug machine from the wall outlet before cleaning and
servicing.
•
For air-operated units, never use the cycle mode for any application other than ribbon
imprinting. Always turn off the cycle mode when not in use.
•
When setting up or changing foil on air-operated units, always turn off power to the
Pneumatic Control Box.
•
Never leave machine handle on the machine when the Pneumatic Control Box is in use.
When air-operated units are to be used as hand operated units, always unplug the power to the
Pneumatic Control Box and disconnect the air hose to the compressor.
To Next Page
Loading...