5
Step 3 – Attach controller and remove the plastic covers.
i) Attach the controller to the belt ensuring you align the magnetic connectors on the rear of the controller to those
on the holster, as shown in Fig. d.
ii) Remove the plastic covers from the black side of all three gel pads as shown in Fig. e. Do not throw these
plastic covers away as you will need to put them back onto the gel pads at the end of each session.
Step 4 - Position the belt on your body.
Wrap the belt around your waist so that the gel pads are pressed firmly against your skin, positioning the large
square gel pad over your navel (belly button). Stretch the ends of the belt around your waist until the small gel
pads are between your hip bones and ribs. Fasten the belt tightly around your waist, but not as tight as to cause
discomfort. See Fig. f.
N
OTE: You can adjust the belt for a smaller waist size by folding over the left end and securing it with the additional
Velcro tab. Then securely fasten the belt around your waist as normal.
Fig. d
Fig. e
Fig. f
To Next Page
Loading...
