EasyManua.ls Logo

Slime 40060 - Usage and Operation; Operational Safety Guidelines; Technical Specifications

Slime 40060
8 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
CAUTION: DO NOT OVERINFLATE!
HOT • DO NOT HOLD IN HAND WHILE OPERATING • PLACE
INFLATOR ON A HARD, CLEAN SURFACE.
1. DO NOT run vehicle while inflator is operating. You may need to be in
“accessory” or “on” position. Please make sure emergency brake is set
and car is in park.
2. Keep inflator out of reach of children.
3. DO NOT use inflator continuously for more than 10 minutes. Allow unit
to cool approximately 25 minutes between uses. Do not leave inflator
unattended.
4. Soft inflatables (i.e. rafts, balls, etc.) may not have recommended
pressure markings. Be careful not to inflate items beyond their capacity.
5. While operating, never block the inflator input or output.
6. For use with 12 volt DC power outlets rated 15 amps or higher. Do not
use with older 8 amp cigarette lighter receptacles.
TIRE INFLATION TIME
CFM (LPM)
DIAL GAUGE
POWER SOURCE
POWER CORD LENGTH
REPLACEABLE FUSE
AIR HOSE LENGTH
TOTAL REACH
LED LIGHT
10 min*
0.53 (15 LPM)**
0-100 PSI / (0-7BAR)
12 volt accessory power outlet
9.7 ft. (2.95 m)
15A 250V 5mm x 20mm
2 ft. (0.6m)
12 ft. (3.66m)
7 Lumens
TECH SPECS
* (0-35 PSI, Standard Tire: P195/65 R15) ** (@ 0 PSI/BAR)

Related product manuals