Slime COMPACT TIRE INFLATOR - Technical Specifications

Ensure that the vehicle is outside, or in an open, well-ventilated area and NOT INSIDE A
CONFINED AREA, SUCH AS A GARAGE as bodily injury or asphyxiation resulting in death
could occur. Always operate the inflator in a well-ventilated area free of combustible
materials, gasoline, or solvent vapors. Always set parking/emergency brake and ensure
vehicle is in Park (or neutral if equipped with manual transmission).
CAUTION: HOT • DO NOT HOLD IN HAND WHILE OPERATING
NOTICE: ENGINE SHOULD BE RUNNING WHILE USING THIS INFLATOR
It is recommended that you operate your inflator with your vehicle’s engine
running to achieve the optimal inflator performance. Never start a vehicle with the
inflator plugged into the DC 12 Volt power socket.
• Do not attempt to disassemble inator.
• No user serviceable parts inside. The only user serviceable part is replaceable fuse.
• Keep inator out of reach of children.
• Place inator on a hard, clean surface.
• Ensure air hose chuck touches the core of the valve stem for proper ination.
• DO NOT use inator continuously for more than 10 minutes. Allow unit to cool
approximately 25 minutes between uses. Do not leave inator unattended.
• ALWAYS use a pressure gauge to check tire pressure. DO NOT over-inate.
• Soft inatables (i.e. rafts, balls, etc.) may not have recommended pressure markings.
Be careful not to inate items beyond their capacity.
• While operating, never block the inator input or output.
• For use with 12 volt DC power outlets rated 15 amps or higher. Do not use with
older 8 amp cigarette lighter receptacles.
VEHICLE EXHAUST WITHOUT PROPER VENTILATION IS EXTREMELY
DANGEROUS. ALWAYS ALLOW FOR PROPER VENTILATION.
TECH SPECS
TIRE INFLATION TIME
CFM (LPM)
DIAL GAUGE
12V POWER CORD LENGTH
POWER SOURCE
TOTAL REACH
* (0-35 PSI, Standard Tire: P195/65 R15)
10 min*
0.44 CFM (12.5 LPM) @ 0 PSI
PSI 0-60, BAR 0-4
9.7 . (2.95 m)
12V accessory power outlet
11.3 . (3.45 m)