Repairing a flat tire with a Smart Spair is simple and takes less
than 15 minutes.
1. Start by rotating tire so that the valve stem is in the lower half of the tire.
2. Slowly remove the valve core with valve core tool provided. Take care
to keep a hold of the valve core as remaining pressure in the tire can
cause the core to shoot out.
3. Allow the tire to fully deflate.
4. Remove the puncturing object if possible.
5.
Place white cap on sealant bottle. Attach filler tube to the bottle tip
and tire valve stem and squeeze in recommended amount of Slime
Tire Sealant.
6. Replace the valve core.
7. Plug the tire inflator into the power outlet. Turn on the inflator
and air up the tire. Use the built-in tire pressure gauge to monitor
inflation progress. Once your correct tire pressure has been
reached, turn off the inflator and disconnect the power adapter.
(The manufacturer’s recommended tire pressure can be found in
the owner’s manual and/or the driver’s side door jamb.)
8. Drive for .2 mi (.32km) and stop to verify that the puncture has been
sealed. Check tire pressure. Reinflate if necessary.
INSTALLATION INSTRUCTIONS
To Next Page
Loading...
