Troubleshooting:
Inflator fails to operate when
plugged in:
1. The fuse, located in the plug
adapter, may have blown.
2. Unscrew the tip of the plug
adapter, remove fuse and inspect. If
necessary, replace fuse with
AGC 15A fuse.
Inflator does not start and fuse has been checked:
1. Push the power plug firmly into the power accessory outlet and
twist it back and forth.
2. Check power accessory outlet for debris and remove if necessary.
Use a nonconductive probe; not fingers or metal.
3. Be sure vehicle power outlet fuse is at least 15 amps. (Vehicle may
need to be turned on to power auxiliary port.)
Inflator runs but does not inflate:
1. Be sure the connector is on the valve stem as far as possible before
closing locking lever.
2. Check tire for leaks and check hose for breaks and leaks at fittings.
Inflator runs slowly:
1. The unit may have overheated from excessive use. Shut it off and
allow it to cool for 25 minutes.
2. Voltage may be too low. Check condition of vehicle’s battery.
HOW MUCH SEALANT PER TIRE?
SCOOTER
MOTORCYCLE
8 oz. (237 mL)
8 oz. (237 mL)
16 oz. (473 mL)
16 oz. (473 mL)
TRAILER
CAR
NOTE: If tire is totally deflated, it is possible that the tire could separate from the
rim, allowing air to leak out when trying to inflate. In the event this occurs, jack
up the vehicle to aid inflation. If this does not work call roadside assistance.
To Next Page
Loading...
