STP8-17TL-BA-BEN112030 | IMEN-STP10-17TL | Version 3.0 EN
PV Inverter
Operation display.
An error has occurred. Please inform your installer .
Bluetooth
®
. Bluetooth Communication active.*
Beware of dangerous electrical voltage.
The inverter operates at high voltages. Any work on the inverter must be carried out
by qualied personnel only.
Beware of hot surface.
The inverter can become hot during operation. Avoid contact during operation.
Observe enclosed documentation.
The inverter must not be disposed of together with the household waste.
Further disposal information can be found in the enclosed installation guide.
CE mark. The inverter complies with the requirements of the applicable EC
guidelines.
RAL quality mark for solar products. The inverter complies with the requirements of
the German Institute for Quality Assurance and Labeling.
Device class label. The inverter is equipped with a wireless component that complies
with the harmonized standards.
Certied safety. The inverter complies with the requirements of the Europe Equipment
and Product Safety Act.
In compliance with Australian mark
In compliance with Korean mark
Direct Current (DC)
Alternating current (AC)
The inverter is protected against penetration by dust particles and water jets from
any angle.
The inverter is transformerless.
* The Bluetooth
®
word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use
of these marks by SMA Solar Technology AG is under license.
Check the inverter and cables for any visual signs of external damage. Contact your installer if you
nd any damage. Do not perform any repair work yourself.
Ask your installer to check for correct inverter operation at regular intervals.
Abbreviation for "alternating current".
Bluetooth
Bluetooth is a radio technology that allows the inverter and other communication devices to
communicate with each other. Bluetooth Communication does not require visual contact between the
devices.
Abbreviation for "direct current".
The Electronic Solar Switch is part of the inverter DC disconnection unit. Electronic Solar Switch must
be securely inserted into the bottom of the inverter and must only be removed by qualied personnel.
Energy is measured in Wh (watt hours), kWh (kilowatt hours) or MWh (megawatt hours). The energy
is the power calculated over time. If, for example, your inverter operates at a constant output of
3 000 W for half an hour and then at a constant output of 2 000 W for another half hour, it has fed
2 500 Wh of energy into the grid within that hour.
Power is measured in W (watts), kW (kilowatts) or MW (megawatts). Power is a momentary value. It
displays the power your Sunny Tripower is currently feeding into the grid.
Abbreviation for photovoltaics.
If you have technical problems, contact your installer. The following information is required in
order to provide you with the necessary assistance:
• Inverter device type
• Inverter serial number
• Type and number of PV modules connected
• Event number or display message on the inverter
• Optional equipment (e.g. communication devices)
Sonnenallee 1
34266 Niestetal, Germany
www.SMA.de
Inverters: +49 561 9522 1499
Communication: +49 561 9522 2499
Fax: +49 561 9522 4699
E-Mail: Serviceline@SMA.de
To Next Page
Need help?
General
