SMA SUNNY BOY 3800-US - Mounting the SMA DC Disconnect; Mounting the Sunny Boy Onto the Wall Mounting Bracket

Mounting SMA America, LLC
32 SB30-40US-IUS103030 Installation Guide
5.4 Mounting the SMA DC Disconnect
Attach the SMA DC Disconnect to the two lower holes of the wall-mounting bracket, using two screws
and washers provided.
1. Place the screws and the washers in the holes in the fastening tabs on the DC Disconnect. The
teeth on the washers must lie against the DC Disconnect's fastening tabs.
2. Place the SMA DC Disconnect against the wall mounting bracket.
3. Tighten the screws with 44 in-lbs. (5 Nm) torque.
☑ The SMA DC Disconnect is mounted.
5.5 Mounting the Sunny Boy onto the wall mounting bracket
1. Remove the handle covers on the right and left side of the Sunny Boy.
2. Transport the Sunny Boy between two persons, using the side handles above and below.
CAUTION
Risk of injury due to the heavy weight of the Sunny Boy. The Sunny Boy weighs approx.
88lbs. (40kg).