SMA America, LLC Maintenance
Installation Guide SB30-40US-IUS103030 83
10.4 Testing the fans
You can verify the operation of the fans in two ways:
• Set the parameter “Fan Test“ to "1" (with Sunny Data, Sunny Data Control or with the data
logger Sunny Boy Control).
or
• Turn off the inverter by turning off all DC and AC disconnects and wait 5 minutes for any residual
voltages to dissipate.
• Once the LEDs are off, remove the cover and set the jumpers as shown below.
• Turn on the inverter by turning on the AC disconnect and then the DC disconnect or switch the
SMA DC Disconnect to the "1" position.
• After testing the fans, remove the jumpers.
Jumper position for verifiying the operation of the fans
To Next Page
Loading...
