6 Electrical Connection
SMA Solar Technology America LLC
Installation ManualSTPTL-US-10-IA-xx-2036
• Loosen the screws of the communication assembly far enough to allow the
communication assembly to be flipped up.
• Flip up the communication assembly until it snaps into place. Make sure that the ribbon
cable is not clamped by the communication assembly or when closing the lower
enclosure lid.
• Insert the network cable into one of the network jacks of the Webconnect Data Module.
• Flip the communication assembly down and fasten the communication assembly screw
hand-tight. Make sure that the ribbon cable is not clamped by the communication
assembly or when closing the lower enclosure lid.
3. Connect the other end of the network cable directly to the computer or router or connect it to
another node. You can only connect the inverter to other nodes via star topology.
4. Commission the inverter (see Section7, page37).
ENGLISH
To Next Page
Loading...
