SMA Sunny Tripower STP 10000TL-10 - 3 Checking Firmware Version

3 Checking Firmware Version SMA Solar Technology AG
10 STPTL10-SBTL20-Display-AT-SG-de_en-12 Service Manual
3 Checking Firmware Version
The new display may only be installed on the following inverters and works with inverters with the
indicated (or later) firmware versions.
• Determine the firmware version installed on the inverter. Use a communication product to access
the firmware version; it will show you the complete firmware version.
If the firmware version on the inverter is lower than specified in the table, update the inverter's
firmware to the specified firmware version or a later one. Perform the firmware update with an
SD memory card or with a communication product (for detailed information about firmware
updates, see the technical description "Firmware Update with SD Memory Card"; for detailed
information about changing parameters, see the manual for the communication product at
www.SMA-Solar.com).
4 Replacing the Display (SB xx00TL-20 and
STP
xx000TL-10)
Figure1: Locking tabs on display retainer
Procedure:
• Remove the defective display.
• Install the new display.
Device type Firmware version
SB 2000HF-30 / 2500HF-30 / 3000HF-30 2.54.11.R
SB 3000TL-20 / 4000TL-20 / 5000TL-20 3.20.05.R
SB 3600TL-20 3.25.05.R
STP 8000TL-10 / 10000TL-10 / 12000TL-10 / 15000TL-10 /
17000TL-10
2.60.08.R