2. Safety instructions
Safety warning
Fully read and follow the safety instructions below before you install, service or use your Smappee
EV Wall. The installer must ensure that the charging station is installed in accordance with the
relevant national and local regulations.
Carrying out activities on this charging station without the relevant knowledge and qualifications can
lead to serious accidents and death. Only carry out tasks for which you are qualified and have been
fully instructed.
Incorrect installation, repairs or modifications can result in danger to the user and may void the
warranty and liability.
Safety precautions
Please observe the following safety precautions to avoid potential electric shock, fire, or personal
injury:
• The charging station is intended exclusively for charging electric vehicles and, when installed
correctly, may be used by untrained individuals.
• Switch off electrical power supply to your charging station before installation or maintenance
work.
• Do not use the charging station if damaged / defective.
• Do not immerse the charging station in water or any other liquids.
• Do not expose the charging station to heat, flame or extreme cold.
• Do not attempt to open, repair, or service any parts. Contact Smappee or your service partner
for further information.
• Only use the charging station under the specified operating conditions.
• Do not allow children to operate a charging station.
• When a charging station is in use, adult supervision of any children present is required.
• While charging the charging cable must be completely unwound and connected to the electric
car without overlapping loops. This to avoid the risk of overheating the charging cable.
Maintenance
• Observe the maintenance schedule.
• Clean the outside only with a dry, clean cloth.
• Do not use abrasive agents or solvents.
• May not be carried out during rain or if air humidity exceeds 95%.
To Next Page
Loading...
