3
Installation
4
Preparation Before Use
3.1 Host Installation
3.3 PIR Installation
4.1 Installation Of GSM/4G-SIM Card
4.2 Quick Setting
4.2.1 Download Mobile App
3.2 Door Sensor Installation
The host should be installed in the center of the alarm place for the best receiving result
from all wireless detectors. Note that the host installation should be as far as possible
away from large-scale metal objects or household appliances with high-frequency
interference, while keep away from the reinforced concrete walls and fire doors and
other shielding materials.
The infrared detector can detect whether there is human movement within a certain range.
When installing, fixed PIR detector on the wall, 2～2.2 meters above ground, adjust the
angle to face the monitored area.
Door sensor is used to sense opening and closing of doors / windows, it consists of one
magnetic bar and one transmitter which are fixed on the door frame (window frame)
respectively by double-side adhesive tape. (Since the glue viscosity will decrease after
long-term use,So it is recommended to use glass glue or super glue to fix.)
Download “ Smart Life” in App Store or Google Play or scan the below QR code to
download the App.
①Please install the SIM card when the host is off.
②Connect the correct DC-5V power adapter, slide the power switch of the host to ON side.
Note:
Host is better intalled in the center of hte defense area.
Door sensor can be installed on the doors\windows\drawers\etc.
PIR detector can be installed 2 meters above the ground ,where human active and easily being
detected.
Note when installing:
Infrared detectors have high sensitivity to human lateral movement, but low sensitivity to longitudinal
movement, so it is best to install detector with direction perpendicular to the direction of human
walking.
Avoid facing outside windows, air conditioners, stoves, sunlight and other places where temperature
change rapidly, places with high air flow rates, and places where pets pass by to avoid false alarms.
There should no large obstructions in its detection range.
If indicator light inside lens keeps on, it means in low battery. Please replace battery in time,
otherwise there may be a false alarm.
Note when installing:
Transmitter should be paralleled with magnetic bar and keep them as close as possible to a distance
less than 10mm.
The weak current indicator lights on, it means the battery is in low power status. Please change
battery in time to avoid alarm failure.
5 6
To Next Page
Loading...