Sealing tyres using the TIREFIT kit
Useful information
The tyre sealant is pumped into the tyre.
TIREFIT is a tyre sealant. TIREFIT is used to
seal punctures of up to 4 mm, particularly
those in the tyre tread, at outside tempera-
tures of up to -20 †.
Please note
G
WARNING
In the following situations, the tyre seal-
ant is unable to provide sufficient break-
down assistance,
as it is unable to seal the
tyre properly:
R
there are cuts or punctures in the tyre
larger than those mentioned above.
R
the wheel rim is damaged.
R
you have driven at very low tyre pres-
sures or on a flat tyre.
There is a risk of an accident.
Do not drive any further. Contact a quali-
fied specialist workshop.
G
WARNING
The tyre sealant is harmful and causes
irritation. It must not come into contact
with your
skin, eyes or clothing or be swal-
lowed. Do not inhale TIREFIT fumes. Keep
tyre sealant away from children. There is a
risk of injury.
If you come into contact with the tyre seal-
ant, observe the following:
R
Rinse off the tyre sealant from your skin
immediately with water.
R
If the tyre sealant comes into contact
with your eyes, immediately rinse them
thoroughly with clean water.
R
If tyre sealant is swallowed, immedi-
ately rinse your mouth out thoroughly
and drink plenty of water. Do not induce
vomiting, and seek medical attention
immediately.
R
Immediately change out of clothing
which has come into contact with tyre
sealant.
R
If an allergic reaction occurs, seek med-
ical attention immediately.
G
WARNING
A tyre temporarily sealed with tyre sealant
impairs the driving characteristics and is
not suitable for higher speeds. There is a
risk of accident.
You should therefore adapt your driving
style accordingly and drive carefully. Do
not exceed the specified maximum speed
with a tyre that has been repaired using
tyre sealant.
The maximum permissible speed for a tyre
sealed with tyre sealant is 80 km/h.
!
After use, excess tyre sealant may run out
of the filler hose. This could cause stains.
Therefore, place the filler hose in the plas-
tic bag that contained the TIREFIT kit.
H
Environmental note
Have the used tyre sealant bottle disposed
of professionally, e.g. at a qualified spe-
cialist workshop.
Comply with the manufacturer's safety
instructions on the sticker on the tyre infla-
tion compressor.
Filling with tyre sealant
X
Leave foreign bodies which have penetra-
ted the tyre in the tyre.
X
Remove the vehicle tool tray.
X
Remove the TIREFIT Kit, consisting of a
tyre sealant bottle and a tyre inflation
compressor, from the vehicle tool kit.
X
Affix the 80 km/h maximum speed sticker to
the instrument cluster within the driver's
field of vision.
150
Sealing tyres using the TIREFIT kit
>> Dealing with accidents and breakdowns.
To Next Page
Loading...
Need help?
General
