EasyManuals Logo

SMART 453 2016 User Manual

SMART 453 2016
200 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #73 background imageLoading...
Page #73 background image
Using the headlamp flasher
X
Pull the combination switch in the direc-
tion of arrow 2.
Switching on the side lamps
X
Turn combination switch control : to the
T
position.
Switching on the foglamps and rear
foglamps
Only vehicles with front foglamps have the
"Foglamps" function.
:
Combination switch middle ring
;
Marking
The side lamps or dipped-beam headlamps
must be switched on.
X
Turn combination switch middle ring : to
the desired marking:
R
O Foglamps
R
R Rear foglamp
After releasing, the combination switch mid-
dle
ring
returns automatically to the neutral
position.
The foglamps and rear foglamps go out auto-
matically in the following situations:
R
the lights are switched off.
R
the engine is switched off and the control
is in the à position.
Using the cornering light function
Only vehicles with front foglamps have the
"Use cornering lights" function.
The cornering light function uses the front
foglamps to improve the illumination of the
road in the direction in which you are turn-
ing, enabling
better visibility in tight bends,
for example.
The following conditions must be fulfilled for
the cornering light function to switch on
automatically:
R
The dipped-beam headlamps are switched
on.
R
The vehicle is moving at less than 40 km/h.
R
The turn signal is switched on or the steer-
ing wheel is turned.
Adjusting the lighting
Adjusting the headlamp range
The vehicle load can affect the headlamp
range. This can impair visibility, and the
headlamps can dazzle oncoming traffic.
The ignition must be switched on in order to
set the headlamp range.
X
Turn the M headlamp range control to
the position
which corresponds to the load
in your vehicle.
R
g: Driver's seat occupied or driver's
seat and front-passenger seat occupied
R
1: Other loading
On-board computer with colour display:
the display shows a message.
Adjusting the dipped-beam headlamps
to left-hand and right-hand traffic
The symmetrical dipped-beam headlamps
are required when travelling in countries
where vehicles are driven on the opposite
Adjusting the lighting
71
>> Ensuring good visibility.
Z

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the SMART 453 2016 and is the answer not in the manual?

SMART 453 2016 Specifications

General IconGeneral
BrandSMART
Model453 2016
CategoryAutomobile
LanguageEnglish

Related product manuals