smarttech.com/kb/171554 14
Chapter 2 Using basic features
Waking up the display and putting it back to sleep 14
Using the Home button 15
Using the front control panel 15
Using the remote control 16
SMARTBoard MX (V3, V2 and V2-C) series 17
SMARTBoard MX series 18
Using touch 19
Writing, drawing, and erasing 21
Writing and drawing in digital ink 21
Using the SMART Ink dynamic (floating) toolbar 21
Changing a pen’s default color, thickness, and other properties 22
Erasing digital ink 22
Adjusting the volume 22
Freezing or hiding the screen 23
Freezing the screen 23
Showing and hiding the screen shade 23
This chapter explains how to wake the display when it’s asleep, how to view connected computers’ input
and how to interact with the display.
Waking up the display and putting it back to sleep
To wake the display, press the Power button on the front control panel or remote control.
To return the display to a partial sleeping state, press the Power button on the front control panel or
remote control.
Note
Touch is not available right after waking up the display or turning it on. Wait a few seconds and then
the display will respond to touch.
For information about turning the display off, see
SMARTBoard MX and MX Pro series interactive
displays installation and maintenance guide
(smarttech.com/kb/171555).
To Next Page
Loading...
Need help?
General
