Chapter 2 Using basic features
smarttech.com/kb/171554 17
SMARTBoard MX (V3, V2 and V2-C) series
The image and table below list the remote control’s functions.
No. Name Procedure
1
Power
l
Press to enter or exit Standby mode (see
Waking up the display
and putting it back to sleep
on page14).
Note
Touch is not available right after waking up the display or
turning it on. Wait a few seconds and then the display will
respond to touch.
l
Press and hold for four seconds to turn off the display.
2 Home Open the iQ Home screen (see
Using the Home button
on
page15).
3 Up and down
buttons
Select a menu option in the settings.
4 OK Select menu option in the settings.
5 Left and right
buttons
Change the value of the selected setting.
To Next Page
Loading...
