10!22 Helpful hints
Tyres and wheels
Removing a wheel
! Park the car on a level surface.
! Apply the handbrake.
! Press the brake pedal and move the
softip gearshift control to position R.
! Switch off the engine.
! Use a suitable wheel wrench to slacken
off the wheel studs by turning them
anticlockwise, but do not remove them
yet.
! Position a suitable car jack at one of
the designated jacking points (A).
These can be identified by
impressions in the door sill area.
>The contact surface of the jack
support must be positioned
vertically below the jacking point
(A).
Accident risk!
Position the car jack only at the
designated jacking points.
If you do not position the jack
correctly, the car could topple off the
jack and injure you or others.
Accident risk!
The jack is intended to lift the
car off the ground for short spells only,
when changing a wheel.
Trestles must be used when conducting
work underneath the car.
Ensure that the jack is resting on a
firm, level surface. On loose surfaces,
place the jack on a stable support that
cannot slip. Do not start the engine
throughout the entire wheel!changing
process.
Do not crawl under the vehicle while it
is raised with the jack. If you raise the
car in a manner other than that
described, it could topple off the jack
(e.g. as a result of starting the engine,
opening or closing a door or the front
or rear luggage compartment).
!"#$%&'()*$#+,,-#.#/01,,2034567(809:;<%%=##>*7)*#--##@%4)&5A#-1;#B=)%<*$#-,,C##??DC?#??
To Next Page
Loading...
