SmartDrive Systems SmartRecorder 4 - SR4 Camera Ports Configurations

Copyright © 2018 SmartDrive Systems, Inc. All rights reserved. This information is intended for the use of SmartDrive 9
customers only. Any other use without the express written consent of SmartDrive Systems, Inc. is strictly prohibited.
SmartRecorder™ 4 Troubleshooting Guide
SR4 Camera Ports Configurations
The SR4 greatly expands configurability for camera usage. In most installations (where SmartDrive Cameras
are being used) the Forward-facing camera will be connected to DCAM-1; the Cab-facing camera will be
connected to DCAM-2.
A. DCAM-1: Forward-facing camera
 Cameras connected to the DCAM-1 port will become the Forward-facing camera.
 NOTE – If a Wabco OnLane 2 Camera is to be used as the Forward-facing camera; a setpoint change
must be made by your account CSM or Project manager before this will function.
B. DCAM-2: Cab-facing camera
 Cameras connected to the DCAM-2 port will be used as the Cab-facing camera.
C. DCAM-3: ADAS camera (not yes released; check back in the future)
D. DCAM-4: 360 Digital camera
 Cameras connected to the DCAM-4 port will be set as a 360 Digital camera.
E. ANALOG1, ANALOG2, ANALOG3, and ANALOG4: 360 Analog Cameras
 See below for further information
 Cameras connected to these ports will be set as 360 Analog Cameras