USER’S MANUAL PAGE 11JSL-1250
sine waveform. It is important to know the continuous wattage of the device
you plan to use with the inverter. The Smartech JSL-1250 Power Station
must be used with devices drawing 400 watts or less. If powering more than
one device, start one device at a time to avoid a power surge and/or inverter
overload. The surge load of each device should not exceed the inverter’s
continuous operation wattage rate.
POWERING A 120V AC DEVICE: Plug the device into 120V AC power
outlet on the front panel. Press 120V AC Power On/Off button rst, then turn
the device on.
NOTE: When this product acts as a power inverter, it sounds an alarm to
alert you that it is in low voltage protection. The inverter also features short
circuit, overheat and overload protection.
WARNING: RISK OF ELECTRIC SHOCK: Incorrect operation of this
product may result in damage and personal injury. The output of this product
is 120V AC and can shock or electrocute the same as any ordinary
household AC wall outlet.
SUPPLY 120V
AC DEVICES
ESTIMATED
WATTAGE
ESTIMATED
RUN TIME
Spotlights, Sump
pumps, DVD players,
100 watts 1.84 HOURS
TVs, Small power
tools
150 watts 1.22 HOURS
Computer, Medium
power tools, Blenders
200 watts 55 MINUTES
To Next Page
Loading...
