Smartech JSL-1250 - AIR COMPRESSOR; Using the Air Compressor; SUPPLY TO 120 V DEVICES; Powering 120 V AC Devices

USER’S MANUAL PAGE 10JSL-1250
AIR COMPRESSOR
SUPPLY TO 120V DEVICES
Read the instructions of the product being inated before using the
compressor. Avoid overination; do NOT exceed the manufacturer’s
recommended pressures. Do NOT leave the air compressor unattended
during use.
1. Take the air compressor hose out from the storage compartment in the
back.
2. Connect the adapter to the valve stem and close the thumb latch.
3. Press Air Compressor On/Off button (the gauge will illuminate imme-
diately) to start power and observe the air compressor gauge until it
reaches the desired pressure. Do NOT leave the air compressor
unattended during ination.
4. Open the thumb latch and remove the connector from the valve stem.
5. Do NOT run for more than 10 minutes at a time. Allow the jump starter
to cool down for 10 minutes before using again.
6. Store the compressor hose in the storage compartment when not in use.
These times are approximate. Use the air compressor gauge to ensure the proper
pressure has been reached. Do not overinate.
ESTIMATED TIME FOR INFLATING
The inverter in this product uses a modied sine waveform, which is not
quite the same as power company electricity. We strongly recommend that
you check the device’s manual to make sure it is compatible with modied
Step 3: Remove the fuse cover and replace the fuse(s).
Step 4: Put the rear panel and bottom rubber panel in position and install
the screws.
Car tire 5 – 9 MINUTES
Bike tire 25 - 30 SECONDS
Sport balls 30 SECONDS