Reset Trip Meter
Hold for 3 seconds to enter settings interface.
Choose option 1, click to reset the trip meter.
Hold for 1 second to save and exit.
Your display is easily controlled with 4 buttons located
on your handlebars.
Power On/Off
Press to start the display and power up the
bike.
To turn off, press and hold the ON/OFF for 3
seconds
Note: the display will power off after 5 minutes
without use.
Pedal Assist
Pedal Assist is controlled with the
buttons. Touch to turn the assist up, and
touch to turn it down.
The power ranges from 0~5. You will notice that
after one turn of the pedals the motor will start
working, assisting you to ride the bike by adding
8. Display Panel Controls
SET
power to the rear wheel. This is the standard or
pedelec mode. To continue using the pedelec mode
you must keep turning the pedals; if you stop the
motor will stop and the bike will slow to a halt. If
you start pedalling again after one turn the motor
will start again.
Depending what country you are in, your throttle
will have different functionalities. In EU and
Australasia, it will work to 6kph unassisted, then
only function above that if you are pedalling. In
other countries it will be fully active whether you
are pedalling or not. If the bike is turned on, always
be careful when mounting the bike that you do not
twist the throttle, as the bike can accelerate away
from you and cause injury. Note: your brake levers
have sensors that will automatically cut motor
power when you use the brakes and restore it when
you release the brake levers.
8. Display Panel Controls
Walk Mode
Press and hold down for 2 seconds to enter
into the mode of power assist walk. The bike will go
on at a uniform speed of 6km/h and display 6km on
the screen.
Information Display
Press to switch the display information. The
order is: Riding time, ODO,Trip
Turning Lights On/Off
With the display on, press to turn on the
bicycle lights (and the lcd backlight). The light
symbol also shows on screen. Press again to
turn off the bicycle lights.
Note: do not hold as the display will turn off.
SET
Set Operations
Hold for 3 seconds to enter setting interface.
Press (don’t hold) to scroll through menu
options.
Press or to adjust the parameters.
Hold for 1 second to save and quit.
SET
SET
SET
SET
SET
Classic user manual.indd 22-23 7/15/2016 4:59:43 PM
To Next Page
Loading...
