Doc. no. AMX-OMU0058-C
-5-
1. Be sure to read before use.
1-1. Handling Precautions
Warning
Confirm the specifications.
This product is designed for use in compressed air systems only.
Do not operate at conditions outside of the specification, as this could cause damage,
malfunction or performance reduction. SMC does not guarantee against any damage if the
product is used outside of the specification range.
Model selection
Carefully consider the application, required specifications, and operating conditions
(pressure, flow rate, temperature, environment and power supply) in accordance with the
latest catalog (SMC website), making sure not to exceed the specification range.
Do not use in the following environments, as it may lead to a breakdown. It may lead to
damage or malfunction.
An environment where corrosive gases, organic solvents, chemical agents or solutions are
present, or a location where these substances may come into contact, and locations where
sea water, water or moisture are present. An area exposed to direct sunlight.(Block direct
sunlight to the product to prevent deterioration due to ultraviolet rays or temperature rise.)
Where the product is exposed to heat sources or in areas that the product is exposed to
radiant heat.
Where impact or vibration is present.
In a location with high humidity and a large quantity of dust.
Outdoors
Mounting on vehicles or vessels (The product might be damaged due to vibration.)
Air source
-Applicable fluid is compressed air.
Do not use this product with a fluid other than compressed air (e.g. oxygen, hydrogen,
inflammable gas, mixed gas, etc.).
-Do not use compressed air which includes chemicals, organic solvents, or corrosive
gases, etc.
It may lead to damage or malfunction.
Do not use for caisson shield, breathing, medical purposes, air blow to any medicines
and foods that enter the human body.
Air preparation equipment including this product is for exclusive use for industrial
compressed air. Do not use for any other purposes.
Do not disassemble (excluding maintenance parts) or alter (additionally machine) the
product.
It may cause injury or accident. SMC does not guarantee against any damage if the product
is disassembled or altered.
To Next Page
Loading...
