Figure 1.1
❍ Once you have established a wireless connection to the router, you can
configure WEP encryption if you are transmitting sensitive data via the
wireless network.
❍ The standard 64bit/128bit/256bit encryption requires you to use the
same set of encryption/decryption keys for the Wireless Barricade Turbo
and all of your wireless clients.
❍ You must have a 10-digit key for 64bit WEP, a 26-digit key for 128bit
WEP and a 58-digit key for 256bit WEP.
❍ To manually configure the keys, enter 5 hexadecimal pairs for your
chosen 64-bit key, enter 13 pairs for the 128bit key or enter 29 pairs for the
256bit key. (A hexadecimal digit is a number or letter in the range 0-9 or A-
F) Also note that the fields are filled in by default. You need to delete these
characters/asterisks before entering your WEP key (For example: To
configure WEP using Key 1, first delete the character entries you see for
Key 1, then enter your desired hex pairs. Do not delete any asterisks from
the other Keys)
To Next Page
Loading...
