SMC Networks HECR002-A5 - HECR Series: Control and Operation; Precise Temperature Control; Learning Control Function

Series
Cooling
capacity
Heating
capacity
Cooling
method
Temperature
stability
Power
supply
Circulating
fl uid
Options
(P.19)
International
standards
Thermo-con/
Rack Mount Type
HECR 002/004/006
200
W
600
W
Peltier-type
air-cooled
±
0.01
to
0.03 °C
Single-
phase
100 to
240 V AC
(50/60 Hz)
Tap wa t er
Ethylene
glycol 20 %
With feet
and
no rack
mounting
brackets
With fl ow
switch
High
pressure
pump
mounted
(UL Standards)
400
W
1
kW
510
W
1.2
kW
Thermo-con/
Rack Mount Type
HECR 008
800
W
1.4
kW
Thermo-con/
Rack Mount Type
HECR 010
1k
W
2
kW
Single-
phase
200 to
240 V AC
(50/60 Hz)
Simple operation
Heat source
Temperature sensor
2/004/006
/
This function adjusts the fl uid temperature
to the set value with an automatic offset
setting. Set the external temperature
sensor at the circulating fl uid inlet located
just in front of the heat source, which
allows the thermo-con to sample the fl uid
temperature. This function is effective
when automatically adjusting for heat
exhaust from piping etc.
Less vibration and noise
with no moving parts such
as a compressor. For HECR
004/006/008/010, noise is
reduced by suppressing the
number of fan rotations
when the cooling load is
low.
If the external temperature sensor is installed directly on the heat source, the learning control
function may not work property due to large heat volume or large temperature difference. Be sure
to install the sensor at the circulating fl uid inlet.
Circulating fl uid volume can be checked.
q Turn the power ON.
w Press the
SEL
key, and adjust the temperature
setting with the
keys.
e Press the
RET
key to complete.
Can precisely control the temperature of a heat source or process fluid.
Precisely control the temperature of the circulating fluid by using the Peltier device.
Refrigerant-free and environmentally friendly.
Learning control function (Temperature control by external temperature sensor)
Low vibration, Low noise
Drain pan
Drain pan is equipped to avoid any
risk of fl uid leakage over equipment
mounted in a lower rack.
Fluid fi ll port
Fluid can be supplied
without removing the
product from the rack.
Power switch
Rack mounting
bracket
Floor type is also available. (Option)
The rack mounting brackets and the handles can be removed and
rubber feet can be mounted instead. (Refer to page 19 for details.)
yp
0
yp
8
/
Variations
1
Peltier-Type Chiller
Thermo-con/Rack Mount Type Series HECR