SMC Networks ISE20B User Manual

-47-
No.PS※※-OMV0006-D
■[F11] Display resolution setting
This function is to change the pressure display resolution.
The flicker of the display can be reduced.
<Operation>
Press the
or button in function selection mode to display [F11].
Press the
button. Move on to display resolution setting.
Press the
button to set. Return to function selection mode.
[F11] Display resolution setting completed
∗: It may not be possible to change the resolution depending on the unit of pressure selected.
The units that allow display resolution to be selected are [MPa], [kPa(ZSE20B(F) only)], [kgf/cm
2
], [bar],
[psi] and [inHg]
(The units [kgf/cm
2
], [bar], [psi] and [inHg] can only be set when using a product with units selection
function.)
Page 30 [F 0] Display units, switch output specifications and diagnostic information selection function
Display resolution setting
Press the or button to select the display resolution.

SMC Networks ISE20B Specifications

General

Brand	SMC Networks
Model	ISE20B
Category	Switch
Language	English