SMC Networks ITV Series - Page 4

Specifications
Voltage
Current
consumption
Voltage type
Current type
Voltage type
Current type
Analog
output
Model
Min. supply pressure
Max. supply pressure
Regulating pressure range
Maximum flow rate
Power supply
Input signal
Input impedance
Output signal
Linearity
Hysteresis
Repeatability
Sensitivity
Temperature characteristics
Operating temperature range
Enclosure
Connection type
Connection size
Weight
24 VDC ±10%, 12 to 15 VDC
0 to 5 VDC, 0 to 10 VDC
4 to 20 mADC, 0 to 20 mADC
Approximately 10 kΩ
Approximately 250 Ω
Within ±1% (Full span)
Within 0.5% (Full span)
Within ±0.5% (Full span)
Within 0.2% (Full span)
Within ±0.12% (Full span)/°C
0 to 50°C (With no condensation)
IP65 equivalent
∗
Built-in One-touch fittings
100 g or less (without options)
ITV001
0.2 MPa
0.001 to 0.1 MPa
3.5 l /min(ANR)
(Supply pressure:
0.2 MPa)
6 l /min(ANR)
(Supply pressure:
0.6 MPa)
ITV003
Set pressure +0.1 MPa
0.001 to 0.5 MPa
6 l /min(ANR)
(Supply pressure:
0.6 MPa)
ITV005
0.001 to 0.9 MPa
Option
Bracket Cable connector
For single
unit
Manifold
Metric size
Inch size
Metric size
Inch size
2 l /min(ANR)
(Supply pressure:
–101 kPa)
ITV009
Set pressure –1 kPa
–101 kPa
–1 to –100 kPa
1.0 MPa
Power supply voltage 24 VDC type: 0.12 A or less
Power supply voltage 12 to 15 VDC type: 0.18 A or less
1 to 5 VDC (Load impedance: 1 kΩ or more)
Output accuracy: Within ±6% (Full span)
z, x, c: ø4
z, x, c:
ø5/32"
z, c:
ø6, x: ø4
z, c:
ø1/4", x: ø5/32"
Flat bracket assembly
P39800022
L-bracket assembly
P39800023
Tighting torque when assembling is 0.3 N·m.
Straight type
M8-4DSX3MG4
Right angle type
ELWIKA-KV4408 PVC025 2M
(1)
Note 1) Indicates the weight of a single unit.
For IITV00-n
Total weight (g) ≤ Stations (n) x 100 + 130 (Weight of end block A, B assembly) + Weight (g) of DIN
rail
Note 2) Specifications other than the following are optional. Pressure range: 0.1 MPa, 0.5 MPa, 0.9 MPa,
Power supply voltage: 24 VDC, Input signal: 0 to 10 VDC
Note 3) When there is a downstream flow consumption, pressure may become unstable depending on
piping conditions.
∗ When using under the conditions equivalent to IP65, connect the fitting or tube to the breathing hole
prior to use. (For details, refer to page 14-8-11 in Specific Product Precautions.)
14-8-4
Series ITV0000
Downloaded from Elcodis.com electronic components distributor