Need help?Do you have a question about the SMC Networks ITV SEN DUX02357 Series and is the answer not in the manual?
General| Brand | SMC Networks |
|---|---|
| Model | ITV SEN DUX02357 Series |
| Category | Controller |
| Language | English |
Explains hazard levels indicated by Caution, Warning, and Danger labels for safe operation.
Emphasizes user responsibility, trained personnel, and critical safety measures before servicing.
Details specific conditions requiring safety measures and interlock circuits for safe operation.
States product use, warranty period, conditions, disclaimers, and compliance requirements.
Lists warnings: no disassembly, operate within specs, avoid hazards; and maintenance advice.
Covers UL requirements, handling, torque, and correct wiring practices to prevent damage.
Discusses environment, hazards (oil, chemicals, surges), and setting operating conditions.
Details power/air cutoff, pressure exhaust, and functional inspections before/after maintenance.
States manual's purpose for ITV setup and defines key terms used throughout the document.
Guides initial network/power connection, IP address setting, and PLC configuration for basic operation.
Details dip switch IP configuration and pneumatic tubing installation with safety emphasis.
Describes power connector layout and Ethernet/IP networking using M12 connectors.
Introduces POE and guides on enabling/disabling it via the ITV web interface.
Describes 'Hold on Connection Loss' and 'Compatibility Mode' functions for specific operating scenarios.
Details PLC signal formatting for setpoint/feedback and the 'Byte Swap' feature.
Explains pressure diagnostics and using counts for setpoint control and feedback.
Covers converting feedback to pressure units and setting engineering units via the webpage.
Explains how User Sensitivity and User Gain affect the ITV's response and control precision.
Guides on accessing the System Information page via browser and logging in to view/change settings.
Describes selecting pressure units and setting/overriding the pressure setpoint via the web page.
Lists system status indicators like System Fault, Bus Fault, and Pressure Error.
Explains how to switch between PLC control and web page control of the ITV.
Describes enabling engineering unit mode and managing login credentials.
Guides on installing the EDS hardware using the Tools menu in RSLogix 5000 for PLC integration.
Explains registering EDS files and adding the ITV as a new module in the PLC I/O configuration.
Details selecting the ITV module and configuring its properties like Name, IP Address, and Definition.
Lists explicit messages for parameters, diagnostics, and configuration settings.
Introduces example graphs to help understand scaling input/output values to and from the PLC.
Guides on diagnosing issues like no power, red LEDs, communication loss, and low voltage.
Explains LED meanings and troubleshooting steps for communication failures, IP address, and DHCP mode.
Addresses differences between web page and master values, and issues reaching set pressure.
Lists necessary items and guides the connection/power up sequence for initial web page access.
Details navigating Windows settings to modify IPv4 properties, focusing on matching the ITV's subnet.
To Next Page