4
About the design
When you pick up the CC-1, know that you are holding a
precision piece of equipment. If treated as such it
should provide you with many years of reliable service.
We have chosen a 9V battery as a power source for a
few reasons:
They are readily available
Isolating the CC-1 from the vehicle’s electrical
system for power, guarantees that it will only
measure what it is supposed to measure; the
audio signal, not noise in the charging system
We also chose an RCA input connector for a few
reasons:
It makes it pretty easy to measure the output of
a headunit directly, if you choose to do so
Should the harness become damaged it is easily
replaceable or repairable in the field
Specifications
Everyone hides these in the back of the book. We are
proud of our specs, they aren’t lies, so we are putting
them up front.
The Crossover Calibrator’s circuitry is computer
controlled
Crossover point accuracy +/- 0.10dB
Gain matching accuracy +/- 0.05dB
Low Battery LED = battery voltage < 6.5Vdc
Auto-shut off timer 8 - 10 minutes after ON
button is pressed
To Next Page
Loading...