13
Troubleshooting:
Problem: The CC-1 is not reading any signal, i.e. the
signal LED won’t illuminate.
Solution: Some amplifiers have the left output on the
Left (+) speaker terminal and the Right output on the
Right (-) terminal. Use left channel, or connect Red
probe to Right (-) and Black to battery ground.
Problem: It just doesn’t seem to be working correctly
Solution: Did you make sure to turn the power off and
then back on if it was previously used and still on? This
is required to reset all of the data the tool gathered
during its last use.
Problem: The signal LED is Red and it won’t do
anything when the READ button is pressed.
Solution: The incoming signal level is too high, reduce
the system volume until the LED turns Green.
Problem: No CD player available
Solution: Tracks can be ripped to MP3, use 192kbps or
higher.
Problem: The CC-1 keeps turning off
Solution: The CC-1 has an auto turn off timer, it will
operate for 8-10 minutes after the “ON” button is
pressed. This is to prevent it from eating your battery
when you forget to turn it off.
Problem: Low battery LED is on…You know what to do
To Next Page
Loading...