9
8. Turn up the source unit volume until you see the
Signal LED illuminate green. If the LED turns
Red, this indicates the volume is too high. Turn
volume down until the LED remains green.
9. When the Signal LED remains Green, press the
READ button.
10. Set crossover switch to High Pass if it has one.
11. Using the LEDs at the top of the CC-1, slowly
turn the crossover frequency adjustment pot
until the CALIBRATED LED illuminates.
12. Congratulations, you have just set the crossover
frequency perfectly!
Setting a Subsonic (Infrasonic) Filter
1. This procedure will set the Subsonic…. rant
mode on…. (Infrasonic is the correct term –
which literally means a sound that has a
frequency that is lower than a human can hear.
Subsonic: A speed or velocity which is slower
than the speed of sound.) ….rant mode off….Ok
this procedure will set the Infrasonic Filter
frequency to a desired set point. This is
accomplished by setting the bass, treble, etc, to
zero; and any EQs and crossovers in the
headunit to flat. When finished, you can reset
the bass, treble, EQ, etc. as desired.
To Next Page
Loading...