11
11. Using the LEDs at the top of the CC-1, slowly
turn the Infrasonic Filter frequency adjustment
pot until the CALIBRATED LED illuminates.
12. Congratulations, you have just set the Infrasonic
Filter frequency perfectly!
Matching the gains of mulitiple amplifiers.
This procedure requires the CC-1 to be placed in a
special mode reserved for SPL competitors and
audiophiles.
1. Switch the CC-1 off by holding the OFF button
for 1 second. (This must be done to initalize
the program mode) Now switch CC-1 power on
by pressing the ON button.
2. Disconnect the harness to make sure there is no
signal being applied to the CC-1 and that the
Signal LED is NOT illuminated.
3. Press and hold the READ button for 3-5
seconds or until the Set LEDs start flashing.
Release Set button. CC-1 is now in
competition mode!!
4. Next you need to connect the CC-1 to the
“Master” amplifier’s outputs. Use the included
harness to connect to amplifier’s outputs; Red to
speaker (+) and Black to battery ground.
To Next Page
Loading...