Installation
79
EN
Make sure that the supply pressure
complies with the values indicated in
section “ Burner and nozzle characteristics
table”.
Gas connection extension cord
(pyrolytic models only)
For pyrolytic models, the supplied gas
connection extension cord must be
installed:
1. undo the screw A at the back of the
appliance, under the gas connection.
2. Use the just removed screw A to fasten
the supplied bracket B to the back of
the cabinet.
3. Carefully screw the connector 3 to the
gas extension cord 1 of the appliance,
placing the seal 2 between them.
To Next Page
Loading...
