EasyManua.ls Logo

Smeg A11XPY-9 - Appliance Positioning

Smeg A11XPY-9
88 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Installation
83
EN
5.3 Positioning
Dimensions
1
Minimum distance from side walls or other
flammable material.
2
Minimum cabinet width (=A).
General information
This appliance can be installed next to
walls, one of which must be higher than the
worktop, at a minimum distance of 50 from
the side of the appliance, as shown in
figures A and C relative to the installation
classes.
Any wall units positioned above the
worktop of the appliance must be at a
minimum distance of at least 750. If a hood
is installed above the hob, refer to the hood
instruction manual to ensure the correct
clearance is left.
Depending on the type of installation, this
Heavy appliance
Crushing hazard
• Position the appliance into the base
cabinet cutout with the help of a second
person.
Pressure on the door
Risk of damage to the appliance
• Never use the oven door to lever the
appliance into place when fitting.
Avoid exerting too much pressure on the
door when open.
• Do not use the handle to lift or move this
appliance.
Heat production during appliance
operation
Risk of fire
• Veneers, adhesives or plastic coatings
on adjacent furniture should be
temperature-resistant (not less than
90 °C).
A 900 mm
B 600 mm
C
1
450 mm
D 900 mm
H 750 mm
I 450 mm
L
2
900 mm

Related product manuals