Smeg CMSC451 User Manual

16
17
3. Remove the drip tray (A11) and grounds container (g.
15).
4. Press the two red release buttons inwards and at the same
time pull the infuser outwards (g. 28).
Important! Do not use washing up liquid to clean the
infuser. It would remove the lubricant applied to the inside of
the piston, causing the infuser to seize up and become unusa-
ble.
5. Soak the infuser in water for about 5 minutes, then rinse
under the tap.
6. After cleaning, replace the infuser (A5) by sliding it onto
the internal support and pin at the bottom;

N.B.: If the infuser is dicult to insert, you must rst
adapt it to the right dimensions by pressing it forcefully from the
bottom and top as shown in the gure.
 -
ped out.
8. Replace the drip tray (A11) and grounds container.
9. Close the service door (A2).
Cleaning the milk container
Important! Always clean the tubes inside the milk
container (B) when you prepare milk. If there is still milk in the
container, do not leave it out of the refrigerator for longer than
strictly necessary. Clean the container each time you prepare

1. Turn the milk container lid clockwise then remove it.
2. Remove the milk spout and intake tube.
Groove
Frothed milk regulator
3. Remove the frothed milk regulator by pulling it outwards.
4. Wash all the components thoroughly with hot water and
mild washing-up liquid.
 
and the groove on the ne end of the frothed milk regula-
tor.
5. Check that the intake tube and spout are not clogged with
milk residues.
6. Replace the frothed milk regulator, milk spout and intake
tube.
7. Replace the milk container lid.
CHANGING AND SETTING MENU PARAMETERS
After turning the knob (C6) to the right or left and waiting
for the appliance to be ready, you can use the internal menu to
modify the following parameters and functions:
 
 
 
Support
Pin
Spout

Hole
Hole

Smeg CMSC451 Specifications

General

Steam pipe	Yes
Product type	Espresso machine
Capacity in cups	2 cups
Coffee input type	Ground coffee
Coffee maker type	Fully-auto
Appliance placement	Built-in
Water tank capacity	1.8 L
Coffee beans capacity	220 g
Maximum operating pressure	15 bar
Type	Coffee/Espresso
Control type	Buttons
Display type	LCD
Product color	Stainless steel
AC input voltage	220–240 V
AC input frequency	50 - 60 Hz

Weight and Dimensions

Depth	361 mm
Width	595 mm
Height	455 mm
Installation compartment width	527 mm
Installation compartment height	368 mm