Smeg CMSC451 User Manual

18
19

 -
an water.
         -
pliance is ready to make coee again.
-
ne still displays the descaling message and the process must be
begun again from the beginning.
Empty the water tank, rinse with clean water and deliver a cup
of hot water.
Important! -

Changing coee temperature
To change coee temperature, proceed as follows:
 -


 
the required coee temperature;
 -
ted;
 

Changing the length of time the appliance remains
on
The appliance is set by default to go o automatically 1 hour
after the last coee has been made.
To increase the number of hours the machine stays on (max. 3),
proceed as follows:
 -


      
hours the appliance remains on.
 
 

Setting water hardness
The descale message is displayed after the appliance has been
operated for a factory set period of time calculated on the basis
of the maximum quantity of limescale which may be contained
in the water used.
The operating period can be extended if required, making de-
scaling less frequent by programming the machine on the basis
of the real lime content in the water used.
Proceed as follows:
 
from its packaging then dip it fully in the water for a few
seconds,
Then remove and wait about 30 seconds (until it changes
colour and forms red squares).
  knob (C6) to the
right or left (g. 6);
          -
ton (C3) repeatedly until the appliance displays “WATER

 
coincides with the number of red squares on the test strip
(for example, if there are 3 red squares on the test strip,

 
The coee maker is now programmed to provide the desca-
le warning when necessary based on the actual hardness
of the water.
Resetting default values (reset)
If you change the original values, the default values can be reset
as follows:
  
-

 

 
 
“READY” message is displayed.
Washing procedure
This function is available to customer services personnel only.
CHANGING THE LANGUAGE

least 5 seconds until the appliance displays the installation mes-
sage in various languages.

the appliance for the rst time”.
TURNING THE APPLIANCE OFF
Each time the appliance is turned o, it performs an automatic
rinse cycle which cannot be interrupted.
Danger of burns! During rinsing, a little hot water
ows from the coee spouts. Avoid contact with splashes of
water.

Smeg CMSC451 Specifications

General

Steam pipe	Yes
Product type	Espresso machine
Capacity in cups	2 cups
Coffee input type	Ground coffee
Coffee maker type	Fully-auto
Appliance placement	Built-in
Water tank capacity	1.8 L
Coffee beans capacity	220 g
Maximum operating pressure	15 bar
Type	Coffee/Espresso
Control type	Buttons
Display type	LCD
Product color	Stainless steel
AC input voltage	220–240 V
AC input frequency	50 - 60 Hz

Weight and Dimensions

Depth	361 mm
Width	595 mm
Height	455 mm
Installation compartment width	527 mm
Installation compartment height	368 mm