Smeg CMSC451 User Manual

10
11
x 4
x 16 x 2
approx. 350mm
x 1
x 4
560 + 1 mm
Position the rails on the sides of the cabinet as shown in the
gure.
Fix with the screws, then extract them completely.
If the coee maker is installed over a warmer drawer (500 W
max.), use the top surface of this as a reference to position the
rails.
In this case, there will be no surface to rest the rails on.
x 4
x 16 x 2
approx. 350mm
x 1
x 4
560 + 1 mm
Fix the power cable with the clip to avoid it tangling when the
appliance is inserted or extracted.
The power cable must be long enough to allow the appliance to
be extracted from the cabinet to ll the coee beans container.
The appliance must be earthed in compliance with legislation.
Electrical connections must be performed by a qualied elec-
trician in compliance with the manufacturer’s instructions and
legislation in force in the country of installation.
The electrical socket must be accessible.
x 4
x 16 x 2
approx. 350mm
x 1
x 4
560 + 1 mm
Position the appliance on the rails, making sure the pins are
correctly inserted in the housings, then x it with the screws
supplied.
x 4
x 16 x 2
approx. 350mm
x 1
x 4
560 + 1 mm
If necessary, correct alignment of the appliance by positioning
the spacers supplied under or at the sides of the support.

Smeg CMSC451 Specifications

General

Steam pipe	Yes
Product type	Espresso machine
Capacity in cups	2 cups
Coffee input type	Ground coffee
Coffee maker type	Fully-auto
Appliance placement	Built-in
Water tank capacity	1.8 L
Coffee beans capacity	220 g
Maximum operating pressure	15 bar
Type	Coffee/Espresso
Control type	Buttons
Display type	LCD
Product color	Stainless steel
AC input voltage	220–240 V
AC input frequency	50 - 60 Hz

Weight and Dimensions

Depth	361 mm
Width	595 mm
Height	455 mm
Installation compartment width	527 mm
Installation compartment height	368 mm