Smeg DD409S - Programming; Selection Program; Start Program

20
PROGRAMMING
In this model of dishwasher, all programming procedures can only be
carried out with the door closed. As long as the door is open, the
PROGRAMS
lights
(4)
and
PHASES/PROGRAM
lights
(7)
will remain
off.
SELECTION PROGRAM
The program selection is possible
through the relative buttons
(2)
.
When the button relating to the program required is pressed, the relative
light will come on to confirm the operation.
START PROGRAM
To start the dishwasher, press the button of the
PROGRAM (2)
required
for a few seconds, until the light of the first phase of the selected
program starts to flash (confirmation beep).
As the program runs, the
PHASES/PROGRAM
lights
(7)
will indicate the
current cycle status.
The light of the phase in progress will
flash, while the lights of the previous and
subsequent phases remain on.
N.B.
during execution of programs which
do not include a prewash, the first
PHASES/PROGRAM
light
(7)
will remain
off.
Pr
e
w
as
h
W
as
h
Rinse
Dr
y
Eco 65°C
P1 P2
P3
P4
P5
User instructions