User instructions
15
END OF PROGRAM
At the end of the program the beeper sounds briefly and the program
lights 4 and 5 (marked "end") flash.
INTERRUPTION A PROGRAM
To interrupt a program in progress:
• press the START/PAUSE button (2); the light of the program in
progress remains on (confirmation beep);
• you may now restart the program by pressing button (2) again until it
restarts, or change or annul the program (see "C
HANGING A
PROGRAM
", or "ANNULLING A PROGRAM").
CHANGING
A PROGRAM
To change the running program it is necessary:
• to interrupt the running program (see “INTERRUPTION A PROGRAM”);
• select the new program;
• start the program (see “S
TARTING THE PROGRAM”).
ANNULLING A PROGRAM
To annul the program, keep the START/PAUSE button (2) pressed until
the program is interrupted (light on and confirmation beep).
Press button (2) again and keep it
pressed until the lights 4 and 5 (marked
"end") come on.
The water in the tank will be pumped out and the program will end at the
point where it was interrupted.
To Next Page
Loading...
