183000
Tilt the appliance so that the bottom hinge can be unscrewed and proceed with disassembling as
shown in the Figure 3. Then fi x the assembly parts again in the opposite turn. Use the attached
opposite hinge insert piece.
Use the bungs, which have been pulled out, on the opposite side. Check the door seal. In case that
it does not rest well, take it off and turn it by 180°.
Necessary tools: ring spanner No.8, screwdriver, torque 25
CONTROL UNIT I
7
Changing the Direction of Opening the Door
Freestanding appliance
Control panel - appliance with electronical regulation
To Next Page
Loading...
