4.3 Cleaning of Shelf
(The picture above is only for reference. The actual configuration will depend on the physical product or statement
by the distributor).
• Please dismantle the cantilever shelf according to the arrows shown as above.
Please hold the front edge of shelf and tilt the shelf inwards until the lower end of fixed leg is separates
from the slot of the supporting iron.
Uplift the whole shelf until it cannot rise anymore.
Take out the shelf horizontally.
• During installation, put the upper end of the fixed leg into one of the upper slots on the supporting glide first
and then put the lower end of the fixed leg into the third slot on the lower part of the supporting glide.
4.4 Cleaning of Freezer Lower Drawer
• Pull out the lower freezer drawer to the proper position.
• As shown in the Figure, press the buttons in both slots respectively (must press both sides at the same
time), pull out the freezer drawer until it stops.
• Take out the lower drawer as directed by the arrows.
• After cleaning, put back the drawer to original position, then close the lower drawer, the button will lock the
drawer automatically.
Note: Don’t remove the lower freezer drawer if not necessary.
Upper end of fixed leg
Lower end of fixed leg
To Next Page
Loading...
