Why is my Smeg LSTA127 Washer/Dryer not spinning?
If your Smeg Washer/Dryer isn't spinning, it may be because the anti-imbalance safety device has been activated due to unevenly distributed laundry. To fix this, rearrange the laundry in the drum by hand and repeat the spin programme.
How to fix Smeg Washer/Dryer that does not start?
If your Smeg Washer/Dryer doesn't start, make sure the plug is correctly inserted into the socket, the door is securely closed, and the “Start/Pause” button has been pressed.
What to do if my Smeg LSTA127 is not filling with water?
If your Smeg Washer/Dryer isn't filling with water, check these things: * Make sure the plug is properly connected. * Ensure the door is securely closed. * Verify that the water tap is turned on. * Check if the water intake hose filters are clogged. * Confirm the water intake hose isn't trapped or kinked.
What to do if Smeg LSTA127 Washer/Dryer is not pumping out water?
If your Smeg Washer/Dryer isn't pumping out water, check that the drain hose isn't kinked and the drain pump isn't clogged.
Why is my Smeg Washer/Dryer not drying laundry?
If your Smeg Washer/Dryer laundry is not dried, verify that the water tap is turned on, the load of laundry isn't too large, the drying time selected is long enough, and the appropriate drying time was selected. If it still does not dry, call the Service Centre to have the fan and drying ducts cleaned to remove any fluff deposits.
How to reduce strong vibrations during spins in Smeg Washer/Dryer?
If your Smeg Washer/Dryer is vibrating strongly during spins, ensure the appliance is properly leveled, not too close to walls or kitchen units, and the internal unit on flexible mounts is locked in position.
What causes too much foam in Smeg Washer/Dryer?
If your Smeg Washer/Dryer has too much foam in the tank that is flowing out of the drawer, check that the detergent used is recommended for automatic washing machines (not for hand washing) and that the quantity used matches the manual's instructions.
Why are the washing results unsatisfactory with my Smeg Washer/Dryer?
If your Smeg Washer/Dryer washing results are unsatisfactory, the manual indicates it could be due to too little or unsuitable detergent, difficult stains not pre-treated, incorrect temperature settings, or an overloaded basket.
What to check if there's water on the floor near my Smeg Washer/Dryer?
If there's water on the floor near your Smeg Washer/Dryer, check that the water intake hose fittings aren't loose and the end of the drain hose is correctly positioned.
How to remove detergent traces on laundry from Smeg LSTA127 Washer/Dryer?
If your Smeg Washer/Dryer leaves traces of detergent on laundry, it may be due to phosphate-free detergents containing substances with low water solubility. To resolve this, select a Rinse programme or brush the laundry.
Critical safety guidelines for installation, use, and general operation of the appliance.
Essential safety measures for electrical connections, earthing, and plumbing.
Prohibits use in hazardous environments, extreme temperatures, or with incorrect hoses.
Covers door safety, handling hot water, child safety, and specific drying risks.
Guidance on placing and ensuring the appliance is level for optimal operation.
Instructions for connecting the appliance to the cold and hot water supply.
Detailed steps for correctly connecting the drain hose to ensure proper drainage.
Essential guidelines for safely connecting the appliance to the electrical power supply.
Explanation of the display, buttons, and programme selector on the appliance's front panel.
Guidance on sorting laundry, understanding care labels, and pre-treating stains.
Instructions on how to load laundry correctly and maximum load capacities.
Guide on using the detergent drawer, types of detergent, and water hardness.
Basic requirements and limitations for drying, including suitable fabrics and load sizes.
A table listing common problems, their potential causes, and checks to perform.
Explains error codes displayed on the appliance and their corresponding solutions.
General| Door hinge | Left |
|---|---|
| Drum volume | 52 L |
| Control type | Buttons, Rotary |
| Loading type | Front-load |
| Tub material | Polypropylene |
| Drum material | Stainless steel |
| Product color | White |
| Built-in display | Yes |
| Appliance placement | Built-in |
| Door panel included | No |
| Drying capacity | 4 kg |
| Washing capacity | 7 kg |
| Delay start (max) | 24 h |
| Spin-drying class | - |
| Maximum spin speed | 1200 RPM |
| Minimum spin speed | 500 RPM |
| Noise level (spin) | 70 dB |
| Noise level (wash) | 56 dB |
| Noise level (drying) | 58 dB |
| Number of drying programs | 2 |
| Number of washing programs | 12 |
| Cycle time washing & drying | 365 min |
| Washing class | A |
| Annual water consumption washing & drying | 18000 L |
| Annual energy consumption washing & drying | 970 kWh |
| Door opening angle | 110 ° |
| Connected load | 2000 W |
| Water consumption washing per cycle | 47 L |
| Energy consumption washing per cycle | 1.02 kWh |
| Water consumption washing & drying per cycle | 90 L |
| Energy consumption washing & drying per cycle | 4.85 kWh |
Weight and Dimensions| Depth | 560 mm |
|---|---|
| Width | 596 mm |
| Height | 820 mm |
| Door opening diameter | 300 mm |
| Installation compartment depth | 584 mm |
| Installation compartment width | 600 mm |
To Next Page
