To Next Page
J
johnsonjefferyAug 19, 2025
What to do if my Smeg WDF147-2 is not pumping out water?
- KKimberly JonesAug 19, 2025
If your Smeg Washer/Dryer isn't pumping out water, check that the drain hose is not kinked and the drain pump is not fouled.
What to do if my Smeg WDF147-2 is not pumping out water?
If your Smeg Washer/Dryer isn't pumping out water, check that the drain hose is not kinked and the drain pump is not fouled.
What to do if my Smeg WDF147-2 Washer/Dryer appliance does not spin?
If your Smeg Washer/Dryer isn't spinning, the anti-imbalance safety device may have tripped because the laundry is not evenly distributed in the drum. If the laundry is still wet at the end of the cycle, rearrange it in the drum by hand and repeat the spin programme only.
Why is my Smeg WDF147-2 shaking with strong vibrations during spins?
Strong vibrations during spins of your Smeg Washer/Dryer can be caused by several factors. Ensure the appliance is properly leveled, not too close to walls or kitchen units, and that the internal unit on flexible mounts is locked in position.
Why is my Smeg WDF147-2 Washer/Dryer laundry not dried?
If your laundry is not drying in your Smeg Washer/Dryer, verify that the water tap is turned on, the load of laundry is not excessive, the drying time selected is long enough, and the appropriate drying time was selected. If the appliance still does not dry the laundry, call the Service Centre to have the fan and drying ducts cleaned to remove any fluff deposits.
Why is my Smeg WDF147-2 laundry not properly spun?
If your laundry isn't properly spun in your Smeg Washer/Dryer, it might be because large items are screwed up and not evenly distributed within the drum. Always wash a mix of large and small items.
What to do if my Smeg WDF147-2 Washer/Dryer appliance does not start?
If your Smeg Washer/Dryer isn't starting, make sure the plug is properly connected to the socket, the door is securely closed, and the ‘Start/Pause’ button has been pressed.
Why is there water on the floor near my Smeg Washer/Dryer?
If you find water on the floor near your Smeg Washer/Dryer, check that the water intake hose fittings are not loose and that the end of the drain hose is correctly positioned.
Why is my Smeg WDF147-2 not filling with water?
If your Smeg Washer/Dryer is not filling with water, check that the plug is properly connected to the socket, the door is securely closed, and the water tap is turned on. Also, ensure the water intake hose filters are not fouled and the water intake hose is not trapped or kinked.
Why is there too much foam in my Smeg WDF147-2 Washer/Dryer?
If there's too much foam in the tank of your Smeg Washer/Dryer, make sure you're using a detergent recommended for automatic washing machines and not for hand washing. Also, ensure the quantity used is as stated in the manual and no more.
Why are my Smeg WDF147-2 Washer/Dryer washing results unsatisfactory?
Unsatisfactory washing results from your Smeg Washer/Dryer may be due to too little or unsuitable detergent, difficult stains not pre-treated, incorrect temperature settings, or an overloaded basket.
General| Brand | Smeg |
|---|---|
| Model | WDF147-2 |
| Category | Washer/Dryer |
| Language | English |
