Why is not all fabric conditioner used in my Smeg Washer/Dryer?
If not all the fabric conditioner is used, or too much water is left in the compartment of your Smeg Washer/Dryer, check that the detergent drawer siphons are correctly fitted and not fouled.
Why does my Smeg Washer/Dryer have traces of detergent on laundry?
If you notice traces of detergent on your laundry after using your Smeg Washer/Dryer, it may be because many phosphate-free detergents contain substances with low water solubility. Try selecting a Rinse programme or brush the laundry.
Why is there no water visible in the washing drum of my Smeg Washer/Dryer?
The absence of visible water in the washing drum of your Smeg Washer/Dryer is not a malfunction. New appliances use very little water to achieve the same washing and rinsing results, so the water level is below the level of the glass in the door.
Why is water not pumped out after last rinse in delicate fabrics and wool wash programmes of my Smeg WDF147-2?
The fact that water is not pumped out after the last rinse in delicate fabrics and wool wash programmes of your Smeg Washer/Dryer is not a malfunction. It is a pause programmed into washing programme to prevent creasing of fabrics. To pump out water, proceed as described in 'Programme End' point.
General| Brand | Smeg |
|---|---|
| Model | WDF147-2 |
| Category | Washer/Dryer |
| Language | English |
To Next Page
