Why is my Smeg Washer/Dryer shaking so much during spins?
If your Smeg Washer/Dryer is vibrating strongly during spins, check that the appliance is properly leveled, it is not too close to walls or kitchen units, and the internal unit on flexible mounts is locked in position.
Why is my Smeg Washer/Dryer laundry not properly spun?
If your laundry is not properly spun in your Smeg Washer/Dryer, it may be because large items are screwed up and not evenly distributed within the drum. Always wash a mix of large and small items.
Why is my Smeg WDF14C7-2 Washer/Dryer not spinning?
If your Smeg Washer/Dryer is not spinning, the anti-imbalance safety device may have tripped because the laundry is not evenly distributed in the drum. If the laundry is still wet at the end of the cycle, rearrange it in the drum by hand and repeat the spin programme only.
What to do if my Smeg WDF14C7-2 Washer/Dryer water is not pumped out?
If the water is not being pumped out of your Smeg Washer/Dryer, check that the drain hose is not kinked and the drain pump is not fouled.
Why is my Smeg Washer/Dryer not starting?
If your Smeg Washer/Dryer isn't starting, ensure the plug is properly connected to the socket, the door is securely closed, and the “Start/Pause” button has been pressed.
What to do if my Smeg WDF14C7-2 is not filling with water?
If your Smeg Washer/Dryer isn't filling with water, check the following: ensure the plug is properly connected to the socket, the door is securely closed, the water tap is turned on, the water intake hose filters are not fouled, and the water intake hose is not trapped or kinked.
Why is my Smeg WDF14C7-2 laundry not dried?
If your laundry is not drying in your Smeg Washer/Dryer, verify that the water tap is turned on, the load of laundry is not excessive, the drying time is long enough, and the appropriate drying time is selected. If it still does not dry, call the Service Centre to have the fan and drying ducts cleaned to remove any fluff deposits.
What to do if water is on the floor from my Smeg WDF14C7-2?
If you find water on the floor near your Smeg Washer/Dryer, check that the water intake hose fittings are not loose and the end of the drain hose is still correctly positioned.
Why is there too much foam in my Smeg WDF14C7-2?
If there's too much foam in your Smeg Washer/Dryer, make sure the detergent used is recommended for automatic washing machines and not for hand washing, and that the quantity used is as stated in the manual and no more.
Why are my Smeg Washer/Dryer washing results unsatisfactory?
Unsatisfactory washing results from your Smeg Washer/Dryer may be due to too little or unsuitable detergent, difficult stains not pre-treated, incorrect temperature settings, or an overloaded basket.
General| Type | Washer/Dryer |
|---|---|
| Loading type | Front loading |
| Washing capacity | 7 kg |
| Drying capacity | 4 kg |
| Maximum spin speed | 1400 rpm |
| Energy efficiency class washing | A |
| Energy efficiency class washing & drying | B |
| Colour | White |
| Product Type | Washer Dryer |
| Brand | Smeg |
| Model | WDF14C7-2 |
| Wash Capacity | 7 kg |
| Dry Capacity | 4 kg |
| Number of Programs | 16 |
| Control Type | Electronic |
| Water Consumption (Wash) | 55 L |
| Noise Level (Wash) | 56 dB |
| Display | LCD |
To Next Page
